Any Recommendations for Alignment
Any Shop in the St Pete Beach or Pinellas County for 05 C6 Coupe front end alignment? Steering wheel is a little to the left when going straight but not pulling and no noticeable tire wear. I can take hands off and it tracks straight?
Thanks in advance:wavey: |
Check with GM Junkie .Send him a PM he's a member on this forum.Depending on your type of driving there are different settings.In my case he set me up so I can get 40,000 miles out of a set of tires :D
|
Bay Area Autodocs..in Largo 12204 66th st.
727-535-0756.They aren't cheap but they are exp. with vettes, and you can stand 5 feet away and watch them work.... It has been a year or so that I used them after lowering my car. I know at the time they were doing alot of vettes............ |
Quote:
(727) 530-3660 12200 66th St, Largo, FL 33773 Have appt next Tuesday - many thanks :wavey: |
Quote:
|
Wheels Lined Up
Thanks for the help. Took it in and Wayne set it to factory specs. (Never got a PM reply from GM Junkie). Turns out the owner & I grew up about 15 miles apart. Wayne took aligning the wheels very seriously - he did a great job! Would recommend him but his work is not a 30 minutes $69.95 special - took him at least two hours and he would have taken all of the time necessary to get it right. The boss said he has seen him take more then four hours.
They invited anyone in the area to come in for Corvette work. Thanks for the recommendation.:wavey: |
Quote:
I set Steve's car up with tried and proven settings of my own that will optimize tire Life,You WILL loose some controllability at HIGH SPEED!!!!(Speeds in Excess 120-140 MPH,If you drive allot at High Speed,These Settings are NOT for you!!) I'll bet Steve's hasn't even seen his age yet, and thats 93!!:lmao::lmao::lmao: Also the car will feel somewhat lighter on the road at all speeds!!:thumbsup::thumbsup::thumbsup: Lt Front 0 camber, 7 1/4*+ caster Rt Front 0 camber, 7 1/2*+ caster 1/32 Toe In Lt Rear 0 camber Rt Rear 0 camber 1/64 Toe In As far as who is good in your area,I haven't a clue! But it sounds like you found a good one!!:thumbsup: |
All times are GMT -4. The time now is 02:01 PM. |
Powered by vBulletin® Version
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.