2007 Z06 stock dyno results
 

Had a chance to get my Z06 dyno'd yesterday at TTP-Engineering. We only did 3 quick runs to see what it would put down.

http://www.youtube.com/watch?v=AYuSXD9jH50

We ended up with 440hp/418tq uncorrected (1.00% correction factor) on a Mustang AWD 500 SE Euro. All runs were close to these numbers. The car is a 2007 with 4400 miles and completely stock except for Mild to Wild.

Ambient temp was 82° F with humidity at 44%. Dyno room temps were probably higher.

http://farm5.static.flickr.com/4015/...81406836_o.jpg

http://farm5.static.flickr.com/4002/...0b377aca_o.jpg

http://farm3.static.flickr.com/2690/...0562c29d_o.jpg

Pretty nice:thumbsup:

That LS7 has some real nice low end torque.... :thumbsup:

Nice numbers! Good looking ride too!

Just finished tuning a bone stock one...432.48/412.55 base & ended up with 470.75/440.15 after the tune. Highest gains I've ever gotten from a tune alone! (this is on a conservative dyno).

^^

Wow, very nice! I am thinking about doing intake/tune but haven't decided yet.

those mustang dyno's are heartbreakers. Its was about 45 less RWHP than the dynocom

Yea, I don't really care about how high/low the number is, just looking for a good baseline to compare with future mods.

What is a "dynocom"?

boost,
If a couple bucks, Ill delete out your torque managment tables, and you'll think you got a new car

I just got mine dynoed on a Land and Sea Dyno.

Mods.
K&N CAI
Ported TB
Ported Intake Manifold
Tuned

Uncorrected was 495whp 481 torque. Uncorrected on a Dyno jet two months ago was 498whp.

Corrected was 505
SAE 486.

Tomorrow header install and re-dyno. I will need to re-tune but probably not tomorrow.