2007 Z06 stock dyno results
Had a chance to get my Z06 dyno'd yesterday at TTP-Engineering. We only did 3 quick runs to see what it would put down.
http://www.youtube.com/watch?v=AYuSXD9jH50 We ended up with 440hp/418tq uncorrected (1.00% correction factor) on a Mustang AWD 500 SE Euro. All runs were close to these numbers. The car is a 2007 with 4400 miles and completely stock except for Mild to Wild. Ambient temp was 82° F with humidity at 44%. Dyno room temps were probably higher. http://farm5.static.flickr.com/4015/...81406836_o.jpg http://farm5.static.flickr.com/4002/...0b377aca_o.jpg http://farm3.static.flickr.com/2690/...0562c29d_o.jpg |
Pretty nice:thumbsup:
|
That LS7 has some real nice low end torque.... :thumbsup:
|
Nice numbers! Good looking ride too!
|
Just finished tuning a bone stock one...432.48/412.55 base & ended up with 470.75/440.15 after the tune. Highest gains I've ever gotten from a tune alone! (this is on a conservative dyno).
|
^^
Wow, very nice! I am thinking about doing intake/tune but haven't decided yet. |
those mustang dyno's are heartbreakers. Its was about 45 less RWHP than the dynocom
|
Yea, I don't really care about how high/low the number is, just looking for a good baseline to compare with future mods.
What is a "dynocom"? |
boost,
If a couple bucks, Ill delete out your torque managment tables, and you'll think you got a new car |
I just got mine dynoed on a Land and Sea Dyno.
Mods. K&N CAI Ported TB Ported Intake Manifold Tuned Uncorrected was 495whp 481 torque. Uncorrected on a Dyno jet two months ago was 498whp. Corrected was 505 SAE 486. Tomorrow header install and re-dyno. I will need to re-tune but probably not tomorrow. |
All times are GMT -4. The time now is 01:37 PM. |
Powered by vBulletin® Version
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.