The ALL Florida Online Corvette Club - C3 FS (For Sale) 1976 4-Speed Coupe

For sale - 1976 Corvette 4-speed - located in Central Florida

https://cimg8.ibsrv.net/gimg/www.cor...3e5a6e4653.jpg https://cimg8.ibsrv.net/gimg/www.cor...3e5a6e4653.jpg

Below is a list of work that has been performed and some that still needs to be completed if desired.

Front suspension:
- New upper and lower Moog ball joints
- New upper and lower control arm bushings
- New sway arm bushings
- New Moog tie rods
- New Moog idler arm
- New poly bushings entire front end
- New timken front bearings
- New power steering hoses
- Rebuilt power steering cylinder
- Rebuilt steering box (Bair’s rebuild)
- New shocks
- New coil springs

Rear suspension:
- Rebuilt rear trailing arms and new bushings
- New half shafts with u-joints (Spicer brand)
- New drive shaft u-joints
- New differential front mount bracket bushing
- New rear end crossmember bushing
- New shocks
- New spring liners installed in the rear spring
- New strut rod bushings
- New transmission mount

Brakes:
- New front and rear stainless steel brake lines (master cylinder to calipers)
- New brake calipers (front and rear)
- New brake rotors (front and rear)
- Rebuilt master cylinder
- New parking brake hardware

Tires and rims
- Front rims are 18” and tires are 255 40 18
- Rear rims are 18" and tires are 275 40 18

Interior:
- Interior is 2 tone (smoke gray and black)
- New smoke gray carpet
- Sound deadener throughout interior
- Interior is in very good shape
- Power windows - both work
- Car does not leak in the rain (I’ll be honest, I don’t test this often)

Transmission:
- M21 muncie four speed
- Transmission was rebuilt using 5speeds.com rebuild kit
- Hurst shifter, recently rebuilt using 5speeds.com rebuild kit
- Lakewood scatter proof bellhousing
- New clutch and pressure plate
- Clutch - hydraulic

Engine
- New aluminum radiator (not a DeWitts)
- New tach board and tach filter
- Edelbrock carburetor
- Metal fuel line from fuel pump to carb
- Edelbrock RPM manifold
- New distributor and spark plug wires
- Headman headers
- New power master starter
- Unknown if any other engine work has been performed

Miscellaneous
- New rear tail and back-up light lens
- 69-75 style steering column (non tilt/telescoping type)

Frame:
- #1 mounts are good
- #2 mounts are good
- #3 mounts are good
- #4 mounts are good
- New body mount bushings all around
- Trailing arm pockets are good (no rust)
- Rocker channels are good
- Visible windshield frame (i.e. what can be seen when interior trim is removed) is good (no rust)

Body/paint:
- Paint looks nice at 10 feet and 10 mph - daily driver quality

Miscellaneous continued:
- Car was born dark brown with saddle interior (now white with black/gray interior)
- Windshield wipers work
- Headlights work
- Engine pad stamp vin number matches pillar post vin number

The Bad:
- Speedometer does not work - I just can’t figure this one out yet
- Clock does not work
- Original radio does not work
- Needs new antenna
- I have found some fiberglass repairs
- Radiator core support has rust in the usual location (very bottom) - I have a spare that is in much better shape that I will include.
- Fan shroud has a few cracks that have been repaired
- Car had AC, but that is long since gone