I got the throttle body from Shaner a little while ago, and although the inside of the inlet bell looked really nice and polished, the outside was really drab looking in comparison. Plus I wasn't too happy with what looked like a flaw in the housing on the top surface. Rather then getting pissy about that flaw, I decided to just bite the bullet and have at it with my Dremel and just polish the outside of the body as well. I could have spent more time with it, but I think I was reaching a point of diminishing returns.
Anyway, I don't think it turned out half bad at all....
Now all I have to do is to install the thing.... It doesn't look hard to do, just finding time is the issue.