[Wanted] Help on 1990 hardtop and C4 parts

[Jeffrey Troop]

100% Disabled veteran needs help. Need to speak with someone who is knowledgeable about parts for a c4 hardtop. I need ALL hardware for main brackets (5 each side), rear screws that go through guide pins in rear (2) front screws and the retainers that are in windshield header panel. Two spacers (GM part # 10137776) that slide over rear guide tubes prior to insertion into receivers into rear deck lid. Also looking for OEM, torx wrench, open end wrench that is used to install this hardware.

Also looking for console and many interior parts.....Can email direct at jtroop1@cfl.rr.com

Thanks for your help

[fletcher4u]

Have you tried Ecklers ?

[Jeffrey Troop]

Thanks for taking the time to try to help. Yes, I have tried Ecklers....They haen't any hardware forthe hardtop, no any knowledge base of entire sub assemblies. Still looking.....Thanks......Jeffrey

[joesroad]

Have you tried Mid America Motorworks or Ebay?

[Jeffrey Troop]

Yes I have, thanks very much....I have found suitable bolts that are required for brackets, but additionally require (extremely difficult to find) the spacers (GM part # 10137776) that slide onto guide posts prior to pushing down into recievers on rear deck lid. This spacer (GM part # 10137776) is part of the overall guide assembly (GM part# 10137774). I cannot find anyone that can even tell me the material, dimensional specs on this spacer. Lets face it here. GM NEVER spent a dime that wasn't necessary back then, so I am very apprehensive in setting the hardtop down onto the car with out them. I believe this spacer was used to prevent the retaining face plates of both the guide assembly and the reciever assembly from gnashing together. I do really appreciate your advise and help. This (corvette's) is all new to me. It's like learning a foreign language.....Thanks so much for the reply and effort. Thanks......Jeffrey

[shakedown067]

You may want to try Corvette recycling. If they don't have it, they might be able to point you in the right direction.

[Jeffrey Troop]

Thanks so much forthe info....It is greatly appreciated.....Called them, looks like they are closed until after the holidays. But will try them and will let you know. I was completely unaware of this source. Thanks again, nothing like help.....to be sure....Jeffrey

[shakedown067]

There is also a used corvette parts place in Tampa. I never can remember the name of the joint. Hopefully the boys at Corvette Recycling can take care of you. It's run by really good people. Have a Merry Christmas!