• Got the Contributing Memberships stuff finally worked out and made up a thread as a sort of "How-To" to help people figure out how to participate. So if you need help figuring it out, here's the thread you need to take a look at -> http://www.corvetteflorida.com/forums/showthread.php?t=3581 Thank you, everyone! Rich Z.

For Sale crane 1.8 shaft mount rockers and 3/8" pushrods

mrr23

mrr23

The Alignment Guy
been sitting around for the last few years after i took them off my 408 motor. there are no bearings in this design. they are a polymatrix bearing. rockers were mikronite finished. i drove my car everyday with them installed. pushrods are 3/8" diameter and 7.250" long. you may need longer/shorter, but will come with the rockers anyway.

they were $1200.00 new. $600.00 shipped to 48 states.

instruction sheet
http://www.cranecams.com/uploads/instructions/563e_.pdf

47828507d1411330838-fs-crane-1-8-shaft-mount-rockers-and-3-8-pushrods-20140908_083819.jpg


47828508d1411330838-fs-crane-1-8-shaft-mount-rockers-and-3-8-pushrods-20140908_083825.jpg


47828509d1411330894-fs-crane-1-8-shaft-mount-rockers-and-3-8-pushrods-20140908_083856.jpg


47828510d1411330894-fs-crane-1-8-shaft-mount-rockers-and-3-8-pushrods-20140908_083846.jpg
 
You must log in or register to reply here.
Back
Top