• Got the Contributing Memberships stuff finally worked out and made up a thread as a sort of "How-To" to help people figure out how to participate. So if you need help figuring it out, here's the thread you need to take a look at -> http://www.corvetteflorida.com/forums/showthread.php?t=3581 Thank you, everyone! Rich Z.

New CNC porting program for the OEM TB's!!

RevXtreme 1

RevXtreme 1

www.revxtreme.com
CNCTBs001.jpg

CNCTBs002.jpg


due to the offset design notive how the pattern condenses on the steeper slope VS the oppisite side to even out the velocity & increase efficiency.

$129 exchange.:thumbsup:
 
Yes. All testing was done this past Jan/Feb at our Tampa facility in our enclosed climate controlled chassis dyno room so conditions were duplicated as close as possible.

The test car was a stock 2001 TA with LS6 intake, long-tubes, & cold air. We showed from 6-8 RWHP gains throughout the entire RPM range with the most evident at the lower RPM's.

This was against both a stock unported OEM unit & our hand ported units that show no noticeable gains but improved lowend throttle response.

It was more than we had expected and this is the result of probably 6-8 months of R&D. Do a Google search on "Pete Incaudo Ported" to see the background of the engineer that was key to this design. :thumbsup:
 
You must log in or register to reply here.
Back
Top