C6 to C5 Interchangability

[Bradzvette]

Thought I would post some of the parts that will work in case anyone is interested.

C6 Z06 Shifter
C6 Z06 shocks
C6 Z51 rotors, see other post for details
LS2 Injectors, 33 lbs. they make an adapter or you can be cheap like I am and splice them in your self to the harness.
C6 Wheels have a different offset and need a wheel adapter

Ok so the list is started, feel free to add verified items.

LS7 Clutch and flywheel, You must loosen the bellhousing a little, but works great.
LS7 Lifters

Thanks

Brad

 

[davekp]

Non Z06 brake pads interchange.

 

[chris308]

Seats.

 

[Bradzvette]

Seats.

I'd like to see a picture of that if you can, I have heard they didn't work. Not doubing you by any means, just curious.

Thanks for contributing.


Brad

 

[chris308]

from the other site..

Here's a breif install tip.

There's 2 ways you can do the install.
1-- This is what I did.
I used the stock C5 seat tracks, bolted the C6 seat to the C5 tracks.and just had to wire the adjustment switch. Not difficult to do. However lumber and heated seat does not work because I didnt have that feature in my car. Passenger side stayed manual-no power adjustment.

2- you can use the complete C6 tracks and seat and run power and ground to the proper wires (have not done this yet but from short research) it should be that simple. The C6 seat tracks will bolt up to the C5.
I will eventually do this-later than sooner (lazy)

The Vette seats (C5 or C6) if bought complete will contain all the module and electrical motors in the assy. All that is necessary is to supply power (12 volts). Again have not actually done this yet.